Categories
new

Move to view larger images

N1201SA UV RF Vector Impedance ANT SWR Antenna Analyzer Meter Tester 140MHz

Price: $194.92
SKU: 127049
0
diggs
Price in points: 1949 points
Points: 18 points
Description

N1201SA UV RF Vector Impedance ANT SWR Antenna Analyzer Meter Tester 140MHz

Description:   
- This instrument has four interfaces: single point measurement, scanning, system information, correction and calibration   
- The default boot into single-point measurement interface.   

Note: For the convenience of the user, each time calibration correction options will automatically change to the user calibration. Meanwhile, in order to ensure the integrity of the calibration, the calibration process, the automatic shutdown function fails, the consistent boot.   

Startup and shutdown   
- Hold down the CTRL key off press the power switch button.   
- The boot state, long press (2S above) the switch button, after the release, the instrument will shut down   
- The boot state, long press (2S above) the switch button, after the release, the instrument will shut down   

Advice when using:   
- In order to ensure the accuracy of measurement and calibration, preheat the instrument at least 15 minutes.   
- Try to use good quality RF cable and connectors.   
- Calibrated cable marked to the next may not need to calibrate and direct use.   
- Test cable process affect the measurement accuracy, it is recommended that, where possible, do not choose too long test cable.   
- Measurement and calibration before, make sure you are not in a strong wireless signal, so as to avoid interference caused by inaccurate measurements.   
- If the impedance measurements themselves do not understand, you can refer to a vector network analyzer instructions and tutorials. This instrument is equivalent to a single-port vector network analysis.   

Specifications: 
- Model: N1201SA
- Working currency  140MHz~2700MHz   
- Stepped frequency  1kHz   
- Display  2.4cun TFT trdp   
- Resolution ratio 320*240(QVGA)   
- Battery capacity: 2000mAH(7.4Wh)   
- Power consumption <1.5W   
- Charge current 400mA   
- Charge port USB   
- Auto power off can be set 5-60minutes   
- Measured parameters  resistence  reactance  standing wave s11   
- Resolution ratio 4 number   
- Frequency accuracy about 5ppm   
- Connector SMA-K   
- Impedance measurement range: 0.1~1000   
- Standing wave measurement range:1.000~65   
- S11(dB)measurement range: 0dB~-60dB   
- Working temperature:0~40 degree   
- Atmospheric pressure:860hPa~1060hPa   

Package included:
- 1 x N1201SA UV RF Vector Impedance ANT SWR Antenna Analyzer Meter

Previous: N1201SA+ NFC RFID Antenna Analyzer RF Vector Impedance Tester Meter 35MHz-2.7GHz

NextUNI-T UT502A Insulation Resistance Tester meter Megohmmeter Voltmeter Continuity

Reviews
Write a ReviewPost PhotosPost Videos, and get GoodLuckBuy points!


No posts found
 

Discussions

Loading...
122